ADE Captiv8-20 Instructions d'exploitation télécharger pdf (Page 9)

Shunt Group

The Shunt Group facility allows part of the protected

premises to be Unset without unsetting the whole

system. This is often used to allow access to a garage

or loading-bay area independently from the main area

of the protected premises. Check your System

Information to see if this facility has been provided.

The detection zones in the shunt group will operate

normally; they will be set when the system is set, and

unset when the system is unset. However, they can

also be Unset (dis-arm) at any time by operating the

shunt group keyswitch. Your installation engineer

will give you details on how to do this.

Re-arming the shunt group is done with the keyswitch.

However, if a detection zone in the group is in fault, eg

a door has been left open, the group cannot be

re-armed. An led located close to the keyswitch may

light, or a buzzer may sound, when it is not possible to

re-arm the shunt group. You must dis-arm the group

by the keyswitch; this will turn off the led or buzzer.

Enter the protected area and clear the faults before

trying to re-arm the group again.

Using the keypad

The operation and programming of the panel is

through routines called menus. There are 7 main

menus, each divided down into sub-menus.

Finding and selecting a menu

On entering Manager code, the keypad will

automatically display the main menu 1 screen.

Use the and keys to move up and

down the main menus and press the key to

access the menu required. The keypad will then

display the sub-menus attributed to the main menu.

Again using the and keys to move

up and down the sub-menus and press the

key to access the required function.

Item selector

When programming you will often be required to move

through lists. This is done by using the and

keys. An arrow on the right of the display

indicates what is selected for programming.

Text description

Each user is identified within the system by a fully

selectable 12 character text label.

During the programming of text description the

numerical keys are used to select the number or the

letters printed on the right of each key. For example if

letter C is required. C is printed as part of ABC on key

2, so press until C is showing on the display and

then the cursor moves to the next character position.

The key is used in the same way for 1 or the

following characters-.,/.The keyisused for 0 or

space.

Captiv8-20

OMIT

RESET

ENTER

2 3

5 6

7 8

ENTER

Intelligent Security & Fire Ltd

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 27 28

Commentaires sur ces manuels

Pas de commentaire

ADE Captiv8-20 Instructions d'exploitation Page 9

Commentaires sur ces manuels

Produits connexes et manuels pour Systèmes de contrôle d'accès de sécurité ADE Captiv8-20